Two side adjustable tiling spreader trowel box 10/12mm 38-66cm

  

Two-Sided Trowel box Stainless Steel trowel tool TEETH 10 and 12mm trowel for bathroom tile Tiling Spreader kit 38cm/15" to 67cm/26" Tile spreader for laying tiles (up to 67 cm) both on the floor and on the walls. Made of Stainless Steel with a thickness of 1.5 mm. The teeth width and height 10mm and 12mm (layer thickness is adjustable).

The width of the box 670 mm. The design is completely disassembled, which makes it easier to transport. It is intended for laying tiles of different sizes from 38 to 67 cm. (If the tile size is less than the partition that comes in the kit). We present to your attention a sliding ridge, which greatly simplifies work on laying tiles to the floor and is possible in use when mounting a tile on the walls. The toothed comb allows you to apply glue into both the floor, the wall and, directly, on the tile. Comb can be used with all tiled adhesives. Using tthis transformer- comb, the glue application process on the floor was managed not only to speed up several times, but also to improve the quality of the applied adhesive uniform thickness of the layer over the entire length, no samples of tile and re-adding adhesive, performance, etc. Also, the purity of the work is another important factor. With a comb, the application process is much more careful than conventional gear spatulas. The width of the applied layer may vary with the help of convenient locks from 100mm to 660mm. The comb is made of a stainless steel with a thickness of 1.5mm, which is characterized by an increased resource of use and resistance to abrasion. Also does not damage the glazed coating of ceramics. The process of applying glue on the tile: With the help of clamps or self-screws, we embarrass the improvised machine for applying glue. Fix the comb 4 by self-reserves in the OSB plate or plywood at the same time sorting it on the required length of the tile.

Under the teeth we stick your tile, pressing it to one edge of the comb. With the help of retainers on the side walls of the comb fix the teeth of the transformer over the tile. After that, exhibit the application width using an additional plank supplied in the kit. Next, we fall asleep the glau on the tile inside the ridge and pushing the tile through the Trowel Box.